截面贯穿植入复材筋法加固钢筋混凝土短梁的抗剪承载力

玻璃钢/复合材料 ›› 2017, Vol. 0 ›› Issue (1): 11-15.

截面贯穿植入复材筋法加固钢筋混凝土短梁的抗剪承载力

李劲松, 刘华新, 赵琳^*, 薛佳宇

辽宁工业大学土木建筑工程学院,锦州121001

收稿日期:2016-07-14 出版日期:2017-01-28 发布日期:2017-01-28
通讯作者: 赵琳(1973-),女,硕士,副教授,研究方向为工程结构加固,lgliuhuaxin@163.com。
作者简介:李劲松(1992-),男,硕士研究生,研究方向为工程结构加固。
基金资助:
辽宁省自然科学基金项目(2015020208);辽宁工业大学教师启动基金(X201223);辽宁工业大学大学生创新创业训练计划项目(201601095)

SHEAR CAPACITY OF RC SHORT BEAMS STRENGTHENED BY ETS METHOD

LI Jin-song, LIU Hua-xin, ZHAO Lin^*, XUE Jia-yu

Civil Engineering & Architecture College of Liaoning University of Technology, Jinzhou 121001, China

Received:2016-07-14 Online:2017-01-28 Published:2017-01-28

摘要/Abstract

摘要： 为了探讨ETS法抗剪加固混凝土短梁的破坏过程、破坏形态及抗剪承载力,对4根钢筋混凝土短梁进行试验研究和理论分析。采用我国《混凝土结构设计规范》(GB 50010—2010)、美国规范(ACI318-05)的计算值和试验值进行对比分析,计算值均比较保守。研究结果表明:钢筋混凝土短梁采用ETS法抗剪加固后,加固筋的存在延缓了裂缝的发展,提高了开裂荷载和抗剪承载力,表现出良好的受力和变形性能。

关键词: 抗剪加固, ETS法, 拉-压杆模型, 抗剪承载力

Abstract: This paper explores the destruction progress, failure modes and shear capacity for the reinforced concrete beams shear strengthened with ETS method, according to the study and analysis on 4 RC beams. According to relative analysis between "Code for design of concrete structures (GB 50010—2010)" and "Building Code Requirements for Structural Concrete (ACI 318-05) and Commentary (ACI 318R-05)", calculated values are more conservative than experimental values. The results indicate that reinforced bars can delay the development cracking, improve the cracking load and shear capacity of the beam. The RC beams strengthened by ETS method show good mechanical and deformation properties.

Key words: shear strengthening, ETS method, STM, shear capacity

中图分类号:

TB332

李劲松, 刘华新, 赵琳, 薛佳宇. 截面贯穿植入复材筋法加固钢筋混凝土短梁的抗剪承载力[J]. 玻璃钢/复合材料, 2017, 0(1): 11-15.

LI Jin-song, LIU Hua-xin, ZHAO Lin, XUE Jia-yu. SHEAR CAPACITY OF RC SHORT BEAMS STRENGTHENED BY ETS METHOD[J]. Fiber Reinforced Plastics/Composites, 2017, 0(1): 11-15.

参考文献

[1] 刘华新, 柳根金, 白云鹏, 等. ETS法加固钢筋混凝土短梁抗剪性能试验研究[J]. 混凝土与水泥制品, 2014(11): 64-67.
[2] 刘华新, 柳根金, 孔祥清, 等. 纤维增强复合材料抗剪加固混凝土梁试验研究进展[J]. 科技导报, 2016, 34(2): 94-98.
[3] Barros JA, Dalfré G. Assessment of the Effectiveness of the Embedded Through-Section Technique for the Shear Strengthening of Reinforced Concrete Beams[J]. Strain, 2013, 49(1): 75-93.
[4] Valerio P, Ibell TJ, Darby AP. Deep embedment of FRP for concrete shear strengthening[J]. Proceedings of the Institution of Civil Engineers-Structures and Buildings, 2009, 162(5): 311-321.
[5] Mofidi A, Chaallal O, Benmokrane B, et al. Experimental tests and design model for RC beams strengthened in shear using the embedded through-section FRP method[J]. Journal of Composites for Construction, 2012,16(5): 540-550.
[6] 混凝土结构设计规范: GB 50010—2010[S].中国建筑工业出版社, 2010.
[7] 王苏岩, 周英武, 李宏男. FRP加固钢筋混凝土梁的抗剪计算方法[J]. 防灾减灾工程学报, 2008(2): 171-176.
[8] 王文炜, 李果. FRP加固钢筋混凝土梁抗剪承载力计算方法研究[J].公路交通科技, 2006(2):106-110.
[9] 闫续, 滕海文, 霍达. 中美FRP加固钢筋混凝土梁抗剪设计规范比较[J]. 混凝土, 2012(02): 28-30.
[10] 成勃, 周群会, 赵林杰. 混凝土梁抗剪承载力加固新方法的试验研究[J]. 建筑结构, 2012(4): 144-147.
[11] Building code requirements for structural concrete and commentary: ACI 318-05, CI 318R-05[S]. Farmington Hills, MI: American Concrete Institute, 2002.
[12] El-Demerdash W E, El-Metwally S E, El-Zoughiby M E, et al. Behavior of RC Shallow and Deep Beams with Openings Via the Strut-and-Tie Model Method and Nonlinear Finite Element[J]. Arabian Journal for Science and Engineering, 2015, 1-24.
[13] El-Zoughiby M E, El-Metwally S E, Al-Shora A T, et al. Strength prediction of simply supported r/c deep beams using the strut-and-tie method[J]. Arabian Journal for Science and Engineering, 2013, 38(8): 1973-1991.
[14] Godat A CO. Strut-and-tie method for externally bonded FRP shear-strengthened large-scale RC beams[J]. Composite Structures, 2013, 99: 327-338.
[15] 龚昊骏. 钢筋混凝土深梁STM模型设计方法[D]. 西安: 长安大学, 2014.
[16] 魏巍巍, 贡金鑫. 按我国规范的压杆-拉杆设计方法[J]. 建筑结构学报, 2008, 29(S1): 287-293.
[17] 夏飞, 张春华. 欧洲规范拉-压杆模型设计分析[J]. 中外公路, 2015, 35(3):163-169.
[18] 叶列平, 孟杰, 王宇航. 拉-压杆模型在钢筋混凝土深梁设计中的应用[J]. 建筑科学与工程学报, 2009, 26(2): 81-86.
[19] 刘立渠, 王娟娟, 韩继云, 等. 钢筋混凝土简支深梁静力性能试验研究及拉压杆模型分析[J]. 建筑结构学报, 2013, 34(10): 137-143.