CFRP方管单钉连接结构强度试验与数值模拟

玻璃钢/复合材料 ›› 2019, Vol. 0 ›› Issue (8): 35-41.

CFRP方管单钉连接结构强度试验与数值模拟

朱秀杰,熊超^*,尹德军,殷军辉

陆军工程大学石家庄校区,石家庄050003

收稿日期:2018-12-04 出版日期:2019-08-28 发布日期:2019-08-28
通讯作者: 熊超(1978-),男,博士,副教授,主要从事基于纤维复合材料的装备轻量化方面的研究,xiongchao@tsinghua.org.cn。
作者简介:朱秀杰(1994-),男,硕士,主要从事复合材料结构设计与力学分析方面的研究。
基金资助:
军队重点攻关项目(ZS2015070132A12002)

STRENGTH TEST AND NUMERICAL SIMULATION OF CFRP SQUARE TUBE SINGLE-NAIL CONNECTION STRUCTURE

ZHU Xiu-jie, XIONG Chao^*, YIN De-jun, YIN Jun-hui

Shijiazhuang Campus of Army Engineering University, Shijiazhuang 050003, China

Received:2018-12-04 Online:2019-08-28 Published:2019-08-28

摘要/Abstract

摘要： 对四种螺栓直径不同的碳纤维层压成型方管单钉连接结构进行压缩试验,得到了连接结构的压缩极限破坏载荷和载荷-位移曲线,分别建立了基于能量演化的复合材料方管螺栓连接结构渐进损伤分析模型,模拟复合材料方管螺栓连接结构压缩载荷下的失效过程和失效模式,分析了不同螺栓直径下CFRP层合方管的孔边应力分布和损伤扩展情况。基于验证过的有限元模型,深入分析了铺层角度的变化对CFRP方管极限压缩载荷的影响。

关键词: CFRP方管, 单钉连接, 渐进损伤分析, 极限压缩载荷

Abstract: The compression test of four kinds of carbon fiber laminated square tube single-nail connection structures with different bolt diameters was carried out, and the compressive ultimate failure load and load-displacement curve of the joint structure were obtained. The energy evolution-based composite square tube bolt connection structure was established respectively. The progressive damage analysis model simulates the failure process and failure mode of the composite square pipe joint structure under compressive load. The stress distribution and damage propagation of the CFRP laminated square tube under different bolt diameters are analyzed. Based on the verified finite element model, the influence of the change of the ply angle on the ultimate compressive load of the CFRP square tube is analyzed.

Key words: CFRP square tube, single nail connection, progressive damage analysis, ultimate compression load

中图分类号:

TB332

朱秀杰,熊超,尹德军,殷军辉. CFRP方管单钉连接结构强度试验与数值模拟[J]. 玻璃钢/复合材料, 2019, 0(8): 35-41.

ZHU Xiu-jie, XIONG Chao, YIN De-jun, YIN Jun-hui. STRENGTH TEST AND NUMERICAL SIMULATION OF CFRP SQUARE TUBE SINGLE-NAIL CONNECTION STRUCTURE[J]. Fiber Reinforced Plastics/Composites, 2019, 0(8): 35-41.

参考文献

[1] Huhne C, Zerbst A K, Kuhlmann G. Progressive damage analysis of composite bolted joints with liquid shim layers using constant and continuous degradation modes[J].Composite Structures,2010,92(2): 189-200.
[2] 谢鸣九. 复合材料连接[M]. 上海: 上海交通大学出版社, 2011:
129.
[3] McCarthy C T, McCarthy M A. Three-dimensional finite element analysis of single-bolt,single-lap composite bolted joints: partⅡ-effects of bolt-hole clearance[J]. Composite Structures, 2005, 71(2): 159-175.
[4] 何柏灵, 葛东云, 莫与明, 等. T800级碳纤维增强复合材料双剪单钉连接的拉伸试验及强度估算[J]. 复合材料学报, 2016, 33(7): 1540-1552.
[5] Aktas A. Bearing strength of carbon epoxy laminates under static and dynamic loading[J]. Composite Structures, 2005, 67(4): 485-489.
[6] 何柏灵, 葛东云, 杜旭联, 等. 基于连续损伤力学的复合材料单剪螺栓连接强度估算策略[J]. 复合材料学报, 2016, 33(12): 2918-2930.
[7] 李望南, 蔡洪能, 李超, 等. 基于微观力学失效理论的复合材料单钉螺栓连接结构拉伸行为预测[J]. 复合材料学报, 2013, 30(12): 240-246.
[8] Egan B, Mccthy M A, Frizzell R M, et al. Modelling bearing failure in countersunk composite joints under quasi-static loading using 3D explicit finite element analysis[J]. Composite Structures, 2014, 108(2): 963-977.
[9] 冯鹏, 田野, 覃兆平. 纤维增强复合材料拉挤型材桁架桥静动力性能研究[J]. 工业建筑, 2013, 43(6): 36-41.
[10] 邓忠民. 飞行器复合材料结构设计基础[M]. 北京: 北京航空航天大学出版社, 2015: 3-6.
[11] 方海, 徐超, 孙慧明, 等. 复合材料拉挤方管型材螺栓节点承载力试验[J]. 复合材料学报, 2014, 31(3): 809-817.
[12] 崔浩, 闫群, 王向明, 等. 激光选区熔化成形铝合金板与CFRP复合材料层合板螺栓连接结构失效分析方法评估[J]. 复合材料学报, 2017, 34(12): 2762-2769.
[13] Kapidzic Z, Ansell H, Schon J, et al. Quasi-static bearing failure of CFRP composite in biaxially loaded bolted joints[J]. Composite Structures, 2015, 125: 60-71.
[14] Guo H Z, Guang Y S, Guang Y L, et al. Modeling for CFRP structures subjected to quasi-static crushing[J]. Composite Structures, 2018, 184: 41-55.
[15] Jose S, Kumar R R, Jana M K, et al. Intralaminar fracture toughness of crossply laminate and its constituent sub-laminates[J]. Compos Sci Technol., 2001, 61(8): 1115-1122.
[16] ABAQUS Inc., Ltd.. Abaqus the orymanual. Version V6.12[M]. Rhode Island: ABAQUS Inc., Ltd., 2012.
[17] Sokolinsky V S, Indermuehle K C, Hurtado J A. Numerical simulation of the crushing process of a corrugated composite plate[J]. Compos A Appl Sci Manuf., 2011, 42(9): 1119-1126.
[18] Paul W H, Stephen R H. Cohesive zone length in numerical simulations of composite delamination[J]. Engineering Fracture Mechanics, 2008, 75: 4774-4479.