高密经编浮空器蒙皮材料的制备与力学行为研究

复合材料科学与工程 ›› 2020, Vol. 0 ›› Issue (9): 42-47.

高密经编浮空器蒙皮材料的制备与力学行为研究

张成龙^1,2, 陈南梁^1,2, 耿奕², 邵慧奇¹

1.东华大学产业用纺织品教育部工程研究中心,上海201620;
2.东华大学纺织学院,上海201620

收稿日期:2019-12-30 出版日期:2020-09-25 发布日期:2020-09-28
通讯作者: 蒋金华(1978-),男,博士,副教授,主要研究方向为产业用纺织品、特种编织织造技术与复合材料,jiangjinhua@dhu.edu.cn。
作者简介:张成龙(1995-),男,博士研究生,主要研究方向为纺织结构复合材料。
基金资助:
国家重点研发计划项目(2016YFB0303300);中央高校基本科研业务费专项资金项目(2232018G-06)

STUDY ON PREPARATION AND MECHANICAL BEHAVIOR OF HIGH-DENSITY WARP KNITTED AEROSTAT ENVELOPE MATERIAL

ZHANG Cheng-long^1,2, CHEN Nan-liang^1,2, GENG Yi², SHAO Hui-qi¹

1. Engineering Research Center of Textile Technical Education Ministry, Shanghai 201620, China;
2. College of Textiles, Donghua University, Shanghai 201620, China

Received:2019-12-30 Online:2020-09-25 Published:2020-09-28

摘要/Abstract

摘要： 柔性蒙皮的国产化对于实现平流层飞艇等浮空器的工程化应用有着重要的战略意义,由于其服役环境严苛,一般采用高性能特种纤维织成平纹布作为承力层。然而,聚芳酯、PBO等特种纤维目前由国外垄断,价格较高且有对国内禁售的风险。为实现浮空器蒙皮的国产化,本文采用国产的涤纶高密双轴向经编织物与聚酯薄膜通过TPU层压复合,制备了一种新型的高性能低成本飞艇蒙皮材料,并对其拉伸、撕裂以及裂纹响应等力学性能与失效机理进行了试验探讨分析。试验结果表明:涤纶基高密双轴向经编蒙皮力学性能优异(拉伸强度>950 N/cm,撕裂强度>600 N),能够满足浮空器蒙皮力学性能要求,并且可以良好地改善蒙皮材料各向同性的问题,同时发现高密经编蒙皮材料纬向撕裂性能优于经向,并且裂纹的存在使得裂纹区发生应力集中效应,会加剧蒙皮的失效,其强力损失率主要取决于裂纹在横向方向上的投影长度。

关键词: 高密经编织物, 浮空器蒙皮, 力学性能, 数字图像相关技术, 复合材料

Abstract: The localization of the aerostat envelope has important strategic significance for the engineering application of the stratospheric airship. Because of its harsh service environment, high-performance special fibers are generally used to weave plain cloth as the bearing layer. However, special fibers such as polyarylate and PBO are currently monopolized by foreign countries, with higher prices and the risk of domestic bans. In order to realize the localization of aerostat envelope, this paper uses domestic polyester high-density biaxial warp knitted fabric and polyester film to laminate by TPU to prepare a new type of high-performance low-cost aerostat envelope material. The mechanical properties and failure mechanisms such as tensile, tearing and crack response were experimentally analyzed. The test results show that the polyester-based high-density biaxial warp-knitted skin has excellent mechanical properties (tensile strength> 950 N/cm, tear strength> 600 N), which can meet the requirements of aerostat envelope mechanical properties and can improve the isotropic problem of the envelope material. At the same time, it was found that the high-density warp-knitted skin material has better weft tearing performance than the warp direction, and the existence of cracks causes stress concentration effects in the crack zone, which will aggravate the failure of the envelope. And the loss of strength is determined by the projected length of the crack in the transverse direction.

Key words: high density warp knitted fabric, aerostat envelope, mechanical properties, digital image correlation technology, composites

中图分类号:

TB332

张成龙, 陈南梁, 耿奕, 邵慧奇. 高密经编浮空器蒙皮材料的制备与力学行为研究[J]. 复合材料科学与工程, 2020, 0(9): 42-47.

ZHANG Cheng-long, CHEN Nan-liang, GENG Yi, SHAO Hui-qi. STUDY ON PREPARATION AND MECHANICAL BEHAVIOR OF HIGH-DENSITY WARP KNITTED AEROSTAT ENVELOPE MATERIAL[J]. Composites Science and Engineering, 2020, 0(9): 42-47.

参考文献

[1] 孟军辉, 张艳博, 吕明云. 平流层飞艇蒙皮材料织物纤维拔出过程分析[J]. 北京航空航天大学学报, 2014, 40(8): 1149-1153.
[2] 顾正铭. 平流层飞艇蒙皮材料的研究[J]. 航天返回与遥感, 2007, 28(1): 62-66.
[3] 王琳, 陈跃华, 李炜. 飞艇囊体材料的研究进展[J]. 产业用纺织品, 2008, 26(10): 1-4.
[4] 田越, 肖尚明. 平流层飞艇囊体材料的发展现状及关键技术[J]. 合成纤维, 2013, 42(4): 11-15.
[5] 沈军, 谢怀勤. 航空用复合材料的研究与应用进展[J]. 玻璃钢/复合材料, 2006(5): 48-54.
[6] 王绍凯, 马绪强, 李敏, 等. 飞行器结构用复合材料四大核心技术及发展[J]. 玻璃钢/复合材料, 2014(9): 76-84.
[7] MENG J, QU Z, ZHU W, et al. Fatigue damage mechanical model of the envelope material for stratospheric airships[J]. Applied Composite Materials, 2017, 24(4): 837-848.
[8] SHI T, CHEN W, GAO C, et al. Investigation of mechanical behavior of weld seams of composite envelopes in airship structures[J]. Composite Structures, 2018, 201: 1-12.
[9] LIU L, LV M, XIAO H. Tear strength characteristics of laminated envelope composites based on single edge notched film experiment[J]. Engineering Fracture Mechanics, 2014, 127: 21-30.
[10] MINAMI H. Strength of coated fabrics with crack[J]. Journal of Coated Fabrics, 1978, 7(4): 269-292.
[11] MAEKAWA S, SHIBASAKI K, KUROSE T, et al. Tear propagation of a high-performance airship envelope material[J]. Journal of Aircraft, 2008, 45(5): 1546-1553.
[12] 陈建稳, 陈务军, 侯红青, 等. 织物类蒙皮材料中心切缝撕裂破坏强度分析[J]. 复合材料学报, 2016, 33(3): 666-674.
[13] 李阳. 建筑膜材料和膜结构的力学性能研究与应用[D]. 上海: 同济大学, 2007.
[14] 陈建稳. 飞艇蒙皮材料的拉伸及撕裂力学性能研究[D]. 上海: 上海交通大学, 2015.
[15] CHEN J, CHEN W, ZHANG D. Experimental study on uniaxial and biaxial tensile properties of coated fabric for airship envelopes[J]. Journal of Reinforced Plastics and Composites, 2014, 33(7): 630-647.