基于四点弯曲试验分析HPFRCC抗拉特性研究

复合材料科学与工程 ›› 2015, Vol. 0 ›› Issue (5): 16-20.

基于四点弯曲试验分析HPFRCC抗拉特性研究

刘泽军^*, 蔺新艳, 李艳

河南理工大学土木工程学院,河南焦作 454003

收稿日期:2014-11-25 出版日期:2015-05-28 发布日期:2021-09-13
作者简介:刘泽军(1979-),男,硕士,讲师,主要从事高性能混凝土的研究,liuzejun@hpu.edu.cn。
基金资助:
国家自然科学基金资助项目(51208183);河南省科技攻关项目(132102310312);河南省自然科学研究计划项目(12B560006);河南理工大学博士基金资助项目(B2012-032)

RESEARCHES ON TENSILE PROPERTIES OF HPFRCC BASED ON ANALYSIS OF FOUR-POINT BENDING TEST

LIU Ze-jun^*, LIN Xin-yan, LI Yan

School of Civil Engineering, Henan Polytechnic University, Jiaozuo 454003, China

Received:2014-11-25 Online:2015-05-28 Published:2021-09-13

摘要/Abstract

摘要： 单轴抗拉试验(UTT)是目前国际上公认的最能展现HPFRCC抗拉特性的试验方法,但UTT试验操作复杂且对试验要求高,不便于实际工程中的质量控制。本文根据四点弯曲试验的实测荷载-跨中挠度曲线,并结合截面平衡条件及应力与应变分布,建立了采用四点弯曲试验分析HPFRCC抗拉特性的计算方法。计算结果与实测结果的对比表明,该模型能较好地评价HPFRCC的抗拉特性,为今后HPFRCC在实际工程中的大量应用提供了一种间接测定其受拉强度和极限拉应变的分析方法。

关键词: 高性能纤维增强水泥基复合材料, 聚乙烯醇纤维, 四点弯曲, 抗拉特性

Abstract: Uniaxial Tensile Test (UTT) is internationally recognized as the most comprehensive test method which can display the tensile properties of HPFRCC, but the operation of UTT test is so complicated that it is inconvenient to take quality control in practice. According to the measured load-deflection curve of four-point bending test, section equilibrium conditions and stress and strain distribution, the calculating method on tensile properties of HPFRCC was established by evaluating four-point bending test results. The model assumes that the stress distribution of HPFRCC in compressive zone is linear and stress distribution in tensile zone is bilinear, which is in accordance with the performance of HPFRCC and is simple for calculating. Comparisons between the calculated and measured results indicate that proposed model is able to evaluate the tensile properties of HPFRCC, which provides an indirect analysis method on the tensile strength and ultimate tensile strain of HPFRCC for practical application.

Key words: high performance fiber reinforced cement composites, PVA fiber, four-point bending, tensile properties

中图分类号:

TB332

刘泽军, 蔺新艳, 李艳. 基于四点弯曲试验分析HPFRCC抗拉特性研究[J]. 复合材料科学与工程, 2015, 0(5): 16-20.

LIU Ze-jun, LIN Xin-yan, LI Yan. RESEARCHES ON TENSILE PROPERTIES OF HPFRCC BASED ON ANALYSIS OF FOUR-POINT BENDING TEST[J]. COMPOSITES SCIENCE AND ENGINEERING, 2015, 0(5): 16-20.

参考文献

[1] 徐世烺,李贺东. 超高韧性水泥基复合材料研究进展及其工程应用[J]. 土木工程学报,2008,41(6): 45-60.
[2] LI V C. 高延性纤维增强水泥基复合材料的研究进展及应用 [J]. 硅酸盐学报, 2007,35(4): 531-536.
[3] 徐世烺, 李贺东. 超高韧性水泥基复合材料直接拉伸试验研究[J]. 土木工程学报, 2009, 42(9): 32-41.
[4] 胡春红, 赵铁军, 戎涛. 应变硬化水泥基复合材料(SHCC)抗拉性能试验研究[J]. 工业建筑, 2012, 43(3): 102-106.
[5] 李艳, 刘泽军,等. 高性能PVA纤维增强水泥基复合材料单轴受拉特性[J]. 工程力学, 2013, 30(1): 322-330.
[6] Fischer G, Li V C. Effect of fiber reinforcement on the response of structural members[J]. Engineering Fracture Mechanics, 2007, 74(1): 258-272.
[7] Salahuddin Qudah, Mohamed Maalej.Application of Engineered Cementitious Composites (ECC) in interior beam-column connections for enhanced seismic resistance[J]. Engineering Structures, 2014, 69(6): 235-245.
[8] Chang-Geun Cho, Yun-Yong Kim, Luciano Feo, etc. Cyclic responses of reinforced concrete composite columns strengthened in the plastic hinge region by HPFRC mortar[J]. Composite Structures, 2012, 94(7): 2246-2253.
[9] Alessandro D, Davide B, Martin T. Nonlinear cyclic behavior of hybrid fibre concrete structural walls [J]. Engineering Structures,2008, 30(2): 3141-3150.
[10] M. Maalej, S.T. Quek, S.F.U. Ahmed, etc. Review of potential structural applications of hybrid fiber Engineered Cementitious Composites[J]. Construction and Building Materials, 2012, 36(6): 216-227.
[11] Parra-Montesinos G.J., Peterfreund S.W., Chao S.H.. Highly damage-tolerant beam column joints through use of high-performance fiber-reinforced cement composites[J]. ACI Structural Journal, 2005, 102(3): 487-495.
[12] 张君,刘骞. 基于三点弯曲实验的混凝土抗拉软化关系的求解方法[J]. 硅酸盐学报, 2007, 35 (3): 268-274.
[13] Gopalaratnam Vellore S. On the characterization of flexural toughness in fiber reinforced concretes[J]. Cement & Concrete Composites, 1995,17(3): 239-254.
[14] Qian S, Li V C. Simplified inverse method for determining the tensile strain capacity of Strain Hardening Cementitious Composites[J]. Journal of Advanced Concrete Technology, 2007,5(2): 235-246.
[15] Toshivuki Kanakubo, Katsuyuki Shimizu, Makoto Katagiri. Tensile Characteristics Evaluation of DFRCC-Round Robin Test Results by JCI-TC[A]. Proceedings of International RILEM Workshop on High Performance Fiber Reinforced Cementitious Composites in Structural Applications[C].Hawaii:RILEM Publications SARL, 2005.
[16] Maalej M, Li V C. Flexural/Tensile Strength Ratio in Engineered Cementitious Composite[J]. Journal of Materials in Civil Engineering, ASCE, 1994,6(4): 513-528.